Scout Report issue

When scouting certain tiles such as Advanced oases and Castles, the initial scout will have inaccuracies. Troops in the city/oases will not be accurately portrayed in the scout report. Things that may be a factor are sever turnover time and poor connectivity.

As of now, more often than not, I must scout a castle TWO times to be sure it is accurate. It's possible this happens for all castles that have recently been attacked (within previous 24 hours).

Image 1 shows top part of scout report of a castle.

Image 2 shows the bottom part of the same scout report. Notice the difference from the turret count at the top of the report and the turret count at the bottom of the report.

Attached are two images.

Image 1 is a scout report of a castle. Note turret count.

Image 2 is a scout performed of the same castle immediately after the first one. This shows a higher turret count and higher troops count!

This is what I mean that two scouts must be performed to ensure accuracy.

This is already known, but not yet fixed so I'm posting images mainly to point out the peculiar thing about the last troop amount.

As can be seen by the Scout Report and the Combat log, the troop numbers on the Scout report are wrong. Even if you use troop values, you only get a total of 39,223 in combat (for this example).

The top of the scout report shows 1,249,997 troops. The middle of the report displays a breakdown of the troops for a total of 745,569. And the actual troops that show up in combat totals 39,223. The scout report shows numbers nowhere near accurate.

Perhaps in the 1.25M figure the devs are including turrets and the wall? If so, it should not. But then that wouldn't explain why the troop breakdown in the middle of the Scout Report is so far off.

It is peculiar that one of the numbers is accurate in reporting the troops, and that is only the last troop amount. In this case sorcerers. This last troop amount seems to always be correct - but it's the only one.